BLUE LED Driving Lights Switch to suit Toyota Landcruiser 200 series – 2008 to Current
This Switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min’s.
Single Pole Single Throw ON – OFF PUSH switch
Black hard surface
Laser etched Legend
Single upper L.E.D light in BLUE
Single lower L.E.D light in BLUE
Upper light is ON when the switch is pressed IN
Lower light can be wired to separate dash light circuit
Rated at 3Amp 12V
Wire Plug and wiring diagram supplied with switch
This Switch Suits the following models ONLY:
Toyota Prado 150 Series
2010 – Current
Toyota Landcruiser 200 Series
2008 – Current
Toyota RAV4
2006 – 2011
Toyota Hilux GUN Series
09/2015 – Current
Toyota HiAce
2014 – Current
$25.00
In stock (can be backordered)
This 12 volt push switch from AOB is a single throw ON – OFF switch designed to operate your 12 volt accessories. It has a face surface size of 32.5 mm x 22 mm and uses the original mounting hole of the vehicle.
This Switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min’s.
Single Pole Single Throw ON – OFF PUSH switch
Black hard surface
Laser etched Legend
Single upper L.E.D light in BLUE
Single lower L.E.D light in BLUE
Upper light is ON when the switch is pressed IN
Lower light can be wired to separate dash light circuit
Rated at 3Amp 12V
Wire Plug and wiring diagram supplied with switch
This Switch Suits the following models ONLY:
Toyota Prado 150 Series
2010 – Current
Toyota Landcruiser 200 Series
2008 – Current
Toyota RAV4
2006 – 2011
Toyota Hilux GUN Series
09/2015 – Current
Toyota HiAce
2014 – Current
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
The switch is an electronic switch rated at 3amp’s. Therefore in ALL cases the accessory MUST be wired through a fused relay.